Thanks Fuzzion, I'll check it out!

Best

Nimesh

Thank you all for your helpful suggestions- I am taken aback by the response I have had to my first post!

Tobobo, the form contour tool (sandbox tool) is exactly what I was after, thank you. I knew the answer was right under my nose.

To put my question into a bit of context I have attached an amended model, and tried out the curviloft plugin from Fred06, which was suggested by a few of you. I found this to be a highly useful and powerful tool. I was able to create the loft I wanted and use it as a tool to create an accurate barrel vault soffit.

Once again thank you ALL for your contributions.

Best,

Nimesh

Amended barrel vault soffit- thanks to FRED06 and curviloft.

Hi,

I'm new to the forums, I wonder if anyone will be able to help?!?

I need to create a surface between these two arcs. Can't think of how to do it! I know the answer is probably really simple. Can anyone recommend a plugin?

I have attached the simple model- it has the two arcs and a gradient through the middle.

Any help would be fantastic!

Thanks

Nimesh

Arc soffit.skp