@box said:

Attach your model or all we can do is guess.

Ok

3D Piling~.skp

@box said:

You must make the geometry a group or component for it to read volume. If you are seeing area you must be selecting faces.

Hi
Thanks for reply,
Yes I have already made it a group and still nothing??

Hi,

Can anyone explain how to get a cubic meterage for my model of a concrete foundation.

Volume does not display in the entity box other square meter.

I have used Solid Inspector and all is well.

Any thoughts anyone?

Yes I want to create a point in space by entering XYZ points.

Imagine you are doing a drainage run.
I want to plot the next point from the last one.
5m along X
2m along Y
50mm lower than last on Z

Id also like to see all measurements from one point as above.

If i start a new line, is it possible to see the length of X Y and Z????

Hi Is anyone aware of an extension that allows you to see X Y and Z measurements from each other at any point.
I want to be able to select a point and then enter into either of the three boxes.
Currently there is only one box which shows the length.