@thomthom said:

Are you talking about 3d point data or contour data?

For Contour data you can use Sandbox Tools that comes with SU - you might need to enable it under Extensions first.

I had been trying with contour data, but I've always had problems with the sheer number of lines that i have. Does point data work better?

Apologies if I overlooked it when I searched, but is there a good PI/Ruby for converting a topo survey into sketch up?

Thanks

Good Morning All:

Not new to SketchUp either, using for about 4 years on and off, but working to integrate it more into our design work.

Starting off, if someone could point me to a subforum where SU/ACAD workstation configurations are discussed, it'd be much appreciated. The Dell Precision M4300 runs SUPro7 well, but I'm looking into getting a work station that will be dedicated to the heavy end of modeling & rendering.