Hi All,

    I am trying to print off from SU8pro a side of a building that must be 4" tall, and, 4" wide; two of them will be needed for this building, but, when i print it off using the print key within SU8pro, it gives me a side that measures only1" by 1.5"????, so need help please in finding out what im doing wrong........

              Many thanks and regards to all,

                          Tom............ :smile:

Hi all, well, i finaly got it to work, just re installed my O/S,(win xp pro sp3), and it loaded in first time; must have been an overall system O/S problem, and i got a clean system by doing this as well ..........

                   Cheeers all.

                      Tom...........

TIG,

   Cheers and thanks for a swift reply; will take a look later on this evening and, hope, all will work out fine........Regards to you and yours...............

                            Tom......... :smile:

Hello to all,

       Simple question, why after following the guidline for locating said plugin within plugin folder, both the flatterly file and seperate .rb, it will NOT work no matter what i do.

       After looking over the site this plugin is taken from for a FAQ or similar, and finding nothing at all, i turn to all out their who hopefully, can help me to get this sorted............regards and thanks.


                           Tom......... :smile:

Hi to ALL,

 I seem to be at a loss as to why!, my unfolded model, is not being printed off as per the size it is portrade within sketchup 8 as, the measurements found in the model made, are, quite some way off their true size, whats going wrong, and more over, what do i need to do to correct this.

 As a way of explaining better, lets say that a models hight is 2", when the model is printed out from within sketchup print, it is comeing out at just a little over 1" in hight, the other measurements are all so out to this degree as well.

 Hope this is easy to understand, and, some kind person can give me the answer/solution i need.........thanks and regards.


                      Tom.... :smile:

Well, can i first say how wonderful it was to get reply`s back so fast, and so very helpful indeed; my most grateful thanks to all you chaps who gave answers to my problem, it would appear that i will indeed carry on in the ways you have outlined above, this has sorted out my worries and i will now get to work with as i stated, gratitued and thanks to you all...................

                          Tom... :smile:  :sunglasses:

Can any one advise me as to what i must do to be able to draw lines to build the model i am creating when, after finding out that the model must be 3 13/16" long and 2" wide by 1 13/16" high, the said line tool seems to stop or extend but never goes to the point i need, say a line of 3" in total, will either come up to short or to far, WHY???.

When i found this out, i re scled the model upwards using the scle tool, this after a fashion, seems to work, but, what a rigmaroll to have to go to, just to get the size and shape of said model correct, then i am hoping that, by re scaling it back to its original and correct size, all add ons etc etc etc, relating and with the model, will all come out to the correct models scale and over all size.

Is the above, what is required to make a small model, or, can i get pro7 to relate building of models in smaller sizes, by being able to alter its inabilities to give correct line lengths and also, do correct circules and the like, without being to small or to large, in all, pro7 is very irritable in producing models in smaller sizes; hanks for any and all help in this matter, hope my problem as i have protraed it here is easy to understand.

            Regards to one and all in this matter,


                            Tom... :smile:  :sunglasses: