Posts made by Jack Barnhill

This looks like it will be a great tool. I noticed that the description only references metric measurements. Is that determined by the plugin or does the plugin use the units set up in SketchUp?

Thanks to everyone for the feedback. I wasn't really going for a "scene" at this time. I'll repost this when I have completed the rest of the items.

Best regards,
Jack

I new to 3D modeling and rendering but have come to the point where some feedback would be helpful. Below are some Kerky renderings and wire frames of a couple SU models of woodworking tools; Bench Pup and Wonder Pup. I would appreciate any comments, good or bad .

---

---

---

---

---

Hi! I just found this forum thanks to a posting by DaveR on a woodworking website. I've dabbled in various CAD and modeling programs over the years but have never gotten too serious about them. I'm trying desparately to learn as much as I can about SU to help me with woodworking designs and documentation.

I'm looking forward to learning as much as I can on this forum and, eventually, being a contributor.

Jack

I want to thank everyone for there input. I was finally able to create the pulls although they were not as clean as the examples. I'll need some more practice.

Thanks again,
Jack

I have already made this drawer pull for a cabinet and now I want to create an SU model of it for future reference. The pull is curved along its length, width and thickness of the top portion of the pull. I have tried for 3 days now to figure out how to do this curved top in SU with no luck. Any, and all, help would be greatly appreciated. The ortho view of the pull is shown below.

If someone can point me to a tutorial for this, that would be great.

Thanks,
Jack