Thanks for the responses. I neglected to save the version with the problem, but I think I might have had a tiny corner "nipped" off the lower, front corner that was stopping the face from moving back. Can't know for sure due to my error in saving.
F
Latest posts made by fishcad
-
RE: Push-pull problem
-
Push-pull problem
New to SketchUp and just found this forum. I have what seems like a newbie question. As shown in the attached image, I've drawn the profile of a set of stairs but I cannot push the highlighted area back to remove that area. I can pull it out, just not push it in. I've read something about thin edges that cut and thick edges that sit on top of a surface. I don't know how one determines which is created or if it's possible to change an edge from a "thick" edge to a "thin" edge.