Graphics card (ATI Radeon HD 2600) had full OpenGl support. I disabled hardware acceleration and Sketchup did slow a bit, either way opengl is set its working now. Its odd it only does it every now and then irregardless of how big or small a file is being worked on. I downloaded the control software ATI puts out for my graphics card and tweaked the 3d settings. If it comes up again I'll just keep tweaking until the move button is smooth. Thanks for the help Gaieus.

If this was previously covered or asked just send a link. I'm new to Sketchup and its a great program but on my last laptop and my current one whenever I use the move tool the program freezes and says "Not Responding". My new laptop is pretty stout,good graphics card, Ram over 4G's. After about 10 seconds Sketchup re orients itself and continues on. This is the only lag I have. Any help and advice would be great.