Fixed it with Copy/Pasted into a new 2025 .skp
Then used GraphicCoverter to create thumbnails.

Hi Rich,
Any chance you could use that snap for the other 4 points like this:

No insult intended.
I'm trying to see how off the finished star is.
You can see that last snap (Labeled Right) is off.
Lets say my 2mm if perfectly joined with the other 4 points.
But I can't get the points left and right in Sketchup.
So if they are already off on the first snap then multiplied by 10 to get the total discrepency.

Fixed it with Copy/Pasted into a new 2025 .skp
Then used GraphicCoverter to create thumbnails.

Hi all,
New to SU 2025

Some of my thumbnails are just showing the SU App icon.
And others are black.

Any help would be greatly appreciated.

Now a week to recover.
And off the to the shop with intricate cuts to stress about.

corrected-with apologies

Final Sketchup for Star Shaped Fruit Bowel!
Again, Huge thanks for all your support and time!
Fat Star - Miter and Bevel - Final.jpg

Got it.
Click and hold on the green plane.
And release at the back.
Thanks again for your support and patience.

How did you get the Rotate compass to turn black and at 45°?

Ok, now I'm back to where I was designing my table saw sleds.
This design has me cutting 4 intricate cuts. Mitre and bevel on all 4 sides.
My original design has me cutting just 3 intricate cuts.
Leaving the 4th side (top) at right angle.
But leaning/angling over to accomplish the same look.

Thanks for this one, Rich (corrected-with apologies).

Absolute champion.

I get what you are telling me now.

I got caught up in learning how to use the snaps.

Any reason why you don't want to tell me how to use the snaps?

Again, no insult intended.

ok thanks again