Hi,

I'm first timer. I love the SU and its plugins including Dib's window builder. I have a bit of an issue and hope someone can point out what I've done wrong here. I tried to use the window builder latest version 1.1.0 and noticed when I pressed the wall puncher the hole was created but not exactly on the spot where the window is located. The hole is horizontally fine but vertically lower by ~250mm. Note the wall had guide lines on it. If there are no guides on the wall it works perfectly. The problem only appears when guides are present in the wall. I need the guides for placing the window in the correct location.

Tried various tricks but failed to figure out what exactly is happening. Hope you can guide me as I'm beginner. Thanks in advance.

Here's the latest of my model with windows at the right spot that's because I created the hole first then added the window. However I added a sample window at the side of the house with the problem I was talking about. Thanks again for looking into this.