Thank you both, very much. I appreciate it immensely. I reading through the responses and practicing as I go.

Thanks again.

Ok, Angusog, I can see from the video-link that this guy creates his own plane by drawing it.

Is that right? CANT'T use Section Planes? Section Planes are so much easier to POSITION where you want the CUT. But I can't do that, correct?

Frustrating.....

Guys,

Thank you for trying to help me get this, but it’s not working for me.

I can make the pipe, and Rotate it to the horizontal (Along the Red axis).

I use Section Plane and position it to the right of the pipe, and Click. The right side of the pipe gets cut off. If I Double Click the Section Plane, the heavy blue arrows disappear, and whole pipe comes back. Now, with the Move Tool, I can then slide the Plane anywhere left or right (along the length of the pipe). So far so good?

I slide the plane anywhere along the pipe.

Then I Select everything, Right Click for Menu, and click on Intersect/Intersect Selected.

I get this error message:

“No Intersections found between selection set and the rest of model.”

-=-=-=-

I’ve tried many different combinations of selection, positioning, etc. And on different geometry.

What am I doing wrong?

Gaieus,

Thanks for that. But how do you actually cut stuff? Like in the example above of the cut pipe. I don't know what tool is used, or how top position the tool. I've used Planes, but so far the geometry is just hidden behind the plane... nut cut. The geometry behind a plane can be erased?

Thank you.

@angusog said:

Have attached sequence as i understand the question Deane, ok went back and re read post and have added the section cut,

here i use the intersect with selected

1. make flat plane at 90 deg, and grp( makes moving around easier)
2. postition were u want the cut
3. Rotate to desired angle
4. explode the grp
5. select all
6. intersect with selected and remove unwanted geometry

Could you put that in regular terms please? I've been trying to figure out how to cut stuff.

"grp" Group?

What do you use to "position"? How do you position? Please explain "intersect with selected".

Thanks.

What are they for, where do you find them, how do you install them, and finally, how do you call them up in SU?

Thanks

Gaieus,

That works too.

What I had been doing was single-clicking once (click and release) on a grip, dragging it out, and then typing my numbers.

Your way… click (don’t release) drag out… then release… works.

Figures I’d find the one way it doesn’t work first, while trying to learn the program’s features!

Masta,

Yes, I was dragging and attempting to enter my numbers.

You are absolutely correct… a click and then a click… no dragging… brings back the green grips and I can type with the Shift Key no problem.

Thanks very much!

Jean,

Just…. WOW!

Before I start… how do I Smooth Lines?

Just wow and thank you so much! You’re right up there with Rush in my book, now! <smile>

So long as you are not doing anything to take focus away form the VCB holding shift doesn't affect anything else.

Masta, in Scale Mode pressing the Shift Key does. I’ve not noticed this anywhere else, and was freely doing so until attempting a Scale procedure.