can't fill the base of model
-
hi ive been working on this model and the base disappeared, I did a slice at 0.2 and intersected it ,but it won't stay . ill try and upload the file. thanks Deanla vista palm trees.skp
-
It could be that your model units are too large. Tiny geometry like 0.2 will break or disappear easily in SketchUp.
-
Try resetting your model scale.
-
The model is quite large. You have the palm tree at around 43 KM tall. Modeling with the units set to meters is good for 3D printing but this is probably much larger than it needs to be. That said, there are a lot of "forks" in the bottom edges that create problems for Intersect Faces. I deleted the large face and then started stitching from end point to end point to fill in faces. I did a little cleanup at a few points in order to get faces to form but when I was finished it looked like this.
I ran CleanUp3 to remove the unneeded edges.
There'll be some other cleanup such as internal faces and stray edges to remove. Solid Inspector and Solid Inspector2 along with Solid Solver can help with some of that.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement