Junji Okubo chassis
-
It's bloody marvelous mate, watching a classic take shape. Looking forward to the others.
-
Thanks Mike.
There are enough different robots to keep me busy for a few months.
But, at the same time.... https://sketchucation.com/forums/viewtopic.php?f=333&t=72530
The Aronnax. -
First, I've cleaned up the component half.
Simple line connections and then push/pull to both face (deletes shape) and extend. Then some line clean up.
Now I have the basic chassis ready for detailing.
-
The detailing.
It's almost done.
-
And shoot, I see some mistakes already.
-
This is better.
Had do a lot more fiddling. I had the geometry all messed up.
-
Back to detailing.
-
And that's it. Done. YAH!
I made the axle/attachment ports a little bit smaller and completed the details.
Is it exact? Nope, but it's close enough.
-
Moving along. (see above posts for previous steps)
Do not copy this step. The geometry is wrong. Good example of how I mess up a lot before I get it right.
Go further down.
-
Do not copy this step. The geometry is wrong. Good example of how I mess up a lot before I get it right.
Go further down.
Final steps for main rough out.
It's just fiddly detail add-ons after this.
Well this was not as easy as I thought it would be. For some reason SketchUp was fighting me and many lines had to be redone several times. It also took time for me to figure out the curves.
Advertisement