Syd Mead's VEX (model progression)
-
Update
-
I am watchin' you !
-
Looking good Bryan
No pressure at all when the Crème de la crème of the car modeling world writes
"I am watchin' you !"
John
-
Looks really good Bryan! Looking forward to the updates..
-
If no one has any major objections or comments, this is the overall shape I'm proceeding with.
In other words, this is the frame I will finish detailing.
(never post hung over
)
-
Thanks guys, then I will move ahead with this shape.
-
Update
-
coming along nicely
-
Forgive me ,I have not watched carefully the pictures and the model, but i believe the side back panel is not broken like you did. I think it is one plane.
Care to send the model by pm or here if ok and I will try to adjust a bit ? -
@ely862me said:
Forgive me ,I have not watched carefully the pictures and the model, but i believe the side back panel is not broken like you did. I think it is one plane.
Care to send the model by pm or here if ok and I will try to adjust a bit ?The problem is two-fold: Syd's drawings are forced perspectives as I found out doing a photo-match and neither exactly matches the other and the actual clarity of details leaves a lot to be desired. The best I could get from the photo-match was general dimensions.
The second part is the sides are actually warped trapezoids, so the only way SU can complete the surface is to divide it into a polygon. I tried several different ways to manually create the polygons and this was the best compromise I could get as I had the same issue with the front side panels.
It will have to do.
-
Update.
On Elisei's suggestions, I tried to tweak the rear side panel a little more. I like the new results, but still have the problem of it being a warped trapezoid. However, I do like the improvement. I also had the rear face too small, and enlarging it helped.
Other details added.
-
Much better .
For me , the upper edge and the lower edge look parallel .
-
Thanks again for the heads up Elisei. I was able to find a solution that resolved the warped trapezoid problem and now it looks right.
Various detailing roughed in.
-
No problem ! Nicely done !
-
Updates.
Once again, I am rebuilding some previous things as the proportions become more evident.
-
Speaking of which... proportion adjustments.
-
Thanks for the help Elisei. It will take me a few days to dissect your model and incorporate it.
Thanks again.
-
I think yours is better, with just a few tweaks it will be great ! Afterall it is just a hand drawing and things might be bent a little !
-
I started a new job this week, so that's why there have been no updates.
Will have some to show this weekend.
-
Great model, good luck with the job.
Advertisement