sketchucation logo sketchucation
    • Login
    ℹ️ Licensed Extensions | FredoBatch, ElevationProfile, FredoSketch, LayOps, MatSim and Pic2Shape will require license from Sept 1st More Info

    Offset Limited

    Scheduled Pinned Locked Moved Newbie Forum
    sketchup
    4 Posts 3 Posters 6.4k Views 3 Watching
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • B Offline
      blair
      last edited by blair

      I am working with SKpro v7 trying to use push/pull behind a line of objects. Along the wall line I can raise the wall height to whatever height needed at some locations, if I break it down into segments. But if I try to do the entire wall I get the following message “Offset limited to 9”. Previously I have had this happen and could stop at the limited dimension and then start a 2nd push/pull ,from the limited location, and raise the wall to the desired height but sometimes I cannot. Anyone have any suggestions? I have tried removing stray lines etc., which does not solve the problem, but cannot find a solution.

      Thanks!

      1 Reply Last reply Reply Quote 0
      • R Offline
        remus
        last edited by

        Could you post the model? hard to say what your specific problem is otherwise, for my limited brain anyway.

        http://remusrendering.wordpress.com/

        1 Reply Last reply Reply Quote 0
        • GaieusG Offline
          Gaieus
          last edited by

          Definitely the model would help. A lot of things can cause this. Sometimes grouping what you want to extrude - then exploding and intersecting with the model - helps but we should se what's going on.

          Gai...

          1 Reply Last reply Reply Quote 0
          • B Offline
            blair
            last edited by

            Gaieus and remus,

            Thanks for responding! I found the problem to be my newbie failure to recognize the importance of Groups and Componets and to use them.

            1 Reply Last reply Reply Quote 0
            • 1 / 1
            • First post
              Last post
            Buy SketchPlus
            Buy SUbD
            Buy WrapR
            Buy eBook
            Buy Modelur
            Buy Vertex Tools
            Buy SketchCuisine
            Buy FormFonts

            Advertisement