Offset Limited
-
I am working with SKpro v7 trying to use push/pull behind a line of objects. Along the wall line I can raise the wall height to whatever height needed at some locations, if I break it down into segments. But if I try to do the entire wall I get the following message “Offset limited to 9”. Previously I have had this happen and could stop at the limited dimension and then start a 2nd push/pull ,from the limited location, and raise the wall to the desired height but sometimes I cannot. Anyone have any suggestions? I have tried removing stray lines etc., which does not solve the problem, but cannot find a solution.
Thanks!
-
Could you post the model? hard to say what your specific problem is otherwise, for my limited brain anyway.
-
Definitely the model would help. A lot of things can cause this. Sometimes grouping what you want to extrude - then exploding and intersecting with the model - helps but we should se what's going on.
-
Gaieus and remus,
Thanks for responding! I found the problem to be my newbie failure to recognize the importance of Groups and Componets and to use them.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement