Stairs with spiral section. How?
-
Hi all, I'm at a loss here on this piece. I need to make a stair that has a straight run and then a spiral bit. The carriage is about 1' and follows the curve. Any one suggest a method to accomplish this? Attached is a bad rough of what I'm trying to do.
-
-
I'm not sure exactly what you are looking for but this is my first guess.
Close?
Shep
-
Yes! That's it. I have to make several versions. How did you do it? Plugins?
-
-
-
Thanks, I've used that plugin before, but never needed my bends to be at specific places. Obviously I need to look at the tutorials again. Last question. If the stairs are built with details--balustrades, handrail etc--will those bend as well?
-
My previous post was done quickly with solid tools, curviloft and joint push/pull.
This can be done with Make and without plugins. It just takes some hand stiching.
Shep
-
-
Just draw that line and the surface will close.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement