3D fillet
-
Like Round Corner by Fredo?
http://forums.sketchucation.com/viewtopic.php?f=323&t=20485
(watch the video he attached) -
ok, fredo is officialy my idol. After fredo scale now I found this!! Thanks gaieus
-
@jukkoo said:
ok, fredo is officialy my idol. After fredo scale now I found this!! Thanks gaieus
Hehehe, just wait til you find Tools on Surface, Joint Push/Pull, Ghost Comp, and everything else Fredo has written....!
Chris
-
Hi
I am trying to use RoundCorner to fillet into a 3 way corner.
It works in block 1 but not when a wedge is in blocks 2 & 3.
I am trying to do a bracket similar to block 3.
Any help appreciated.
Tim
-
like this?
-
Yes, but if you need this RoundCorner does not work.
-
Hey cotty
That is exactly what I did but the result was quite different as in my model.
So what did I do wrong - different settings maybe?
Tim -
Nope, not exactly!
Followed your steps and it worked.
Redrew it my way and it didn't.
The difference - I drew the web differently.
You drew a rectangular prism then cut it in half diagonally.
I drew the triangle shape of the rib with single lines and then pushed it back.
Go figure! Why would it be different?
Thanks
BTW - like the online video recording. I can use that with my students. -
I think this is the reason for your problem: with your creation of the triangle, some faces gets reversed and there is an inner face...
-
What happens when different fillet radii meet? In attached drawing:
Block 1 - same radius (5) all happy.
Block 2 - 15 radius
Block 3 - 5 radius
Block 4 - 5 radius first and then 15 - not happy.
Block 5 - 15 radius first and then 5 - not happy.
All done with RoundCorner.
Can it be made to work?
-
If you repair one corner by hand, you will see why the plugin has problems to make it...
Advertisement