WIP Assault Rifle
-
Cool, gun nuts
-
Not a 'gun nut' as you put it, I just had a lot of time firing and cleaning a fairly diverse selection as part of my job. Biggest gun I was qualified on was the Chieftain and Challenger 120mm. They do tend to mess up what they hit. They also take a load of time cleaning and then some.
-
Compared to my knowledge of guns, you are a gunnut to me
-
Just started a new WIP. Again opinions very much welcome.
-
Depending on the location of the rear sight, you may want to make the front sight a bit taller otherwise it would not be seen by the firer.
-
@paladin_bs said:
Just started a new WIP. Again opinions very much welcome.
looks good, is this not sketchup however?
-
http://www.theregister.co.uk/2012/07/30/3d_printed_assault_rifle/
now just print it out on your 3D Printer and you're ready to go. crazy.
-
@liam887 said:
looks good, is this not sketchup however?
It was made completely in Sketchup. I just imported to 3DS Max 12 because it looked better.
-
@paladin_bs said:
@liam887 said:
looks good, is this not sketchup however?
It was made completely in Sketchup. I just imported to 3DS Max 12 because it looked better.
Oh ok, have you tried rendering it yet?
-
Redid it to make it better suited for gaming. In essence I made it of components to lower the poly count. Anyway here it is in sketchup and in 3DS Max.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement