WIP Assault Rifle
-
Cool, gun nuts
-
Not a 'gun nut' as you put it, I just had a lot of time firing and cleaning a fairly diverse selection as part of my job. Biggest gun I was qualified on was the Chieftain and Challenger 120mm. They do tend to mess up what they hit. They also take a load of time cleaning and then some.
-
Compared to my knowledge of guns, you are a gunnut to me
-
Just started a new WIP. Again opinions very much welcome.
-
Depending on the location of the rear sight, you may want to make the front sight a bit taller otherwise it would not be seen by the firer.
-
@paladin_bs said:
Just started a new WIP. Again opinions very much welcome.
looks good, is this not sketchup however?
-
http://www.theregister.co.uk/2012/07/30/3d_printed_assault_rifle/
now just print it out on your 3D Printer and you're ready to go. crazy.
-
@liam887 said:
looks good, is this not sketchup however?
It was made completely in Sketchup. I just imported to 3DS Max 12 because it looked better.
-
@paladin_bs said:
@liam887 said:
looks good, is this not sketchup however?
It was made completely in Sketchup. I just imported to 3DS Max 12 because it looked better.
Oh ok, have you tried rendering it yet?
-
Redid it to make it better suited for gaming. In essence I made it of components to lower the poly count. Anyway here it is in sketchup and in 3DS Max.
Advertisement