Modeling issue: Cloth wrapped around a metal structure
-
Wildchild,
For the top and bottom alignment, there is an option in JPP to guide a push pull along a plane.
In your case, if you pres CTRL + ArrowUp, you would force the Horizontal plane
Fredo
-
Dude...I don't want to bother more than I've done but
, I tried this method and it actually does work, the top and bottom are now aligned, the thing is now the faces are not equally insetting anymore 
. Seems like that one excludes the other, as shown below:
Most likely I am not doing it in the right way, in that case, would you be so kind to explain? Thanks
-
Could you please post your particular model above, because I don't obtain the discrepancy you mentioned. On my tests, the extruded faces are parallel to the original face and at the specified distance.
Thanks
Fredo
-
Sure enough I'm doing something wrong.
thanks
-
@wildchild said:
Sure enough I'm doing something wrong.
thanks
If you use the Tape tool to measure the corersponding edge, you will observe that they are strictly parallel at a distance of exactly 20cm. However, the orthogonal distance between faces is smaller.
I'll need to have a look and try to fix that if I can
Fredo
-
I know, I tried to mesure it! what shook me is that the top and bottom are equidistant while the orthogonal faces are not! And as far as i know this is geometrically impossible if the 2 faces are parallel (equidistant). The only solution to this would be that the inset face is not flat, or rather, made by non-coplanar triangles or quad-faces(but that's not the case). Does that even makes sense?
See what you can do! thank you.
-
you could use Smartpushpull plugin.
http://forums.sketchucation.com/viewtopic.php?f=323&t=23341&hilit=smartpushpullI applied it on each faces, then erase unwanted geometries about 5 mn work.
-
@gilles: DUDEEEEEEEEEE!! I say Bingo! it definately does work! how come I haven't noticed this plugin i don't know!
The funny thing is that in the 1001 pro bit tool bar which I have, there's a tool that behaves just like smartpushpull but can't handle small values, infact it wasn't working in this case.
It would be cool to just be able to interanct with the adjacent faces as well.
-
WildChild,
I modified JPP to handle the case of forced plane. This won't work in all situations (as there is no mathematical solution for vertices with more than 3 faces), but it might help for your particular objectives of wrapping box.
See main post of JPP
Fredo
-
Sorry for being ridiculously late in my reply, I've been busy working.
I finally tested your update Fredo, and it works perfectly smooth, and it breezed through the exam!I can't express how gratefull I am! thank you very much! Hope I wont bother anyone with some crazy request for a while!
-
Advertisement