Creating a sphere with large nuber of segments
-
I am trying to create a sphere that is very smooth. I start out with a cirle that has 128 segments and a diameter of 23.5mm.
It will not create a whole sphere. it always leaves a hole at the top and bottom. I even tried a half sphere using an arc but the same problem.
Is this a sketchup limitation or I am just not doing it right. Works OK with 24 segments. -
SU has an issue creating faces smaller than 1mm. Create your sphere 2350mm then scale down by 0.1 and again by 0.1 (or by 0.01) afterwards.
-
Thank you for your quick reply and solution. It works with bigger scale.
-
Its magic
Advertisement