Posts made by wandsworth

Thank you so much TIG!

Not a picture, I know how to do that, yeah I did look at the 3dwarehouse but found nothing good for this purpose..I was thinking to draw one but prob I'm not good enough at this stage...I'm trying though

Hi,

Not sure how to pose this question,I need to insert in a drawing a sort of a modern bronze statue representing a composition of flying doves. I couldn't find any flying birds to insert and eventually modify..
they need to be 3D to give a sense of depth, enough detailed but as a statue..does anybody have any guideline?
Any little help is appreciated..
ps I've attached a picture of what I'm looking for..
Thanks

many thanks for your advices, still have lots to discover about Sketch up..

Attached the altar, i'm quite happy with it, It's more than enough for its purpose.

This forum is gold, as soon as I have time, I will have a proper look.

Thanks!, Is there any way to see the depth of the marble panel ?

altar 1.pdf

Thanks

yes, it's just an appearance; I've attached something similar to what I'm drawing.

I've done the bending surface of the central piece, close up on the right,I need to fix the inlaid green marble panel to it.

thanks

This is the sort of altar i'm trying to draw..as said my issue is the green inlaid marble on the right that lay on a slightly bending surface; I've done the surface behind, I need to fix this panel on top of it, now..

HI!

I'm new and really need some help.
I hope somebody can address me to specific topics in regard of plug ins for extrusion.

Basically I'm trying to draw an altar with marble inlaid; part of the surface, where these pieces lay, slightly bend, not sure what it's the simpliest way to do them, I've tried a few times, but I'm stuck at the moment.

Is there any plug in suitable to help me?

Thanks

Amber