@unknownuser said:

by Alan Fraser on Wed May 09, 2012 10:24 am

Somewhere on this site, or the 3D warehouse there is a DC of an opening door. I think it swings through an angle of about 100° between open and closed. You ought to be able to use pretty much the same parameters...maybe changing 100 to 180.

Thanks Allen I will take a look and see if it works for me.

Jordan,

Hello,

I have been playing around with sketch up for only a little while now and loved what it has done for me...than I found this forum and it blew my mind what some of you have done and can do with this program. I am hooked.
I was originally using SketchUp because the wife is 3D illiterate and it helped show her what I was trying to do for house projects like the deck, shed, bathroom and kitchen.

I do need some help.  I did a model of a folding knife that I want to make. I was wondering if it was possible to make the blade fold out and in with in a set rotational angle, also when the blade is fully open, I want the liner lock to move into the locking position.  Is a dynamic component capable of doing this?

Jordan,