I have been having a blast with the EagleUp plug-in. I draw the circuit with EagleCad, export with EagleUp to Sketchup, Add any components that don't show up and then Render to POV-Ray using SU2POV plug-in. I am getting some really nice finished products in my opinion. Here are a few of my renderings:

I actually changed over to EagleUp and am much happier than I was with Eagle3D. I am able to edit the board and parts without having to code anything. Here is a board that I did with EagleUp and then rendered with the current version of SU2POV and POV-Ray. Much easier and more intuitive!

Awesome! Thanks, Ii will give it a try and report back. Thanks for your helpfulness!

@didier bur said:

Hi,
What version of SU2POV do you need ? I can PM you the one you want.
Regerds,

Hi,

Thanks for your response! Actually I am not sure. I was just looking for an archive so I could find a version the had the same settings on it. If you look at the tutorial I linked to, he has photos of the options from the SU2POV. I know that is a pain, but that's the best answer I can give you. I would say it was around May of 2010 that i last created parts that worked.

Regards,
Jeremy

Hi,

I use Eagle3D with sketchup and SU2POV. I recently updated to the latest version of SU2POV and now it won't work with the tutorial that I was using. Is there an archive of older versions of SU2POV that someone could point me to?

Any advice would be greatly appreciated.

Regards,
Jeremy