I have a simple box and I want to make it non-solid, how would I do that?

Thanks!

I'm trying to import a set of png tile images into one picture like a jigsaw, but when I import into one square the picture pops up in a different one,

Instead of showing up in the sqaure I chose it either goes to the one next to it or above it.

Is there a way to fix this?

@gaieus said:

After you pasted the linework, select all > right click > Intersect > ...selection. If the lines and the faces are coplanar, chances are it will merge the edges with the faces and Z-fighting stops.

Otherwise try to draw over a couple of lines to force merging. Note you can also attach the skp file here.

It worked! Thank you very much!

I'm trying to repeat flat line designs onto a flat surface,

The highlighted is the design I want to replicate throughout the surface

I've tried two methods but both arrive with problems.

Method 1.
Highlighting the lines only and copying and pasting them onto the surface,

it works but once the square snaps to the other line then the pasted version doesn't let you click on a specific part of the design or if I try to paint one section it paints the entire design as if there is no separation between the boxes, example:

If I don't snap it to the existing line it works but then it's not parallel to the other design.

Method 2.
Selecting the entire design with all surfaces inside it,

this method results in z-fighting http://en.wikipedia.org/wiki/Z-fighting

It's as if there is no way to do this simple task properly.

Please help!