Thanks for the reply, Im with you on all of the other points. This whole object is on a 20-25 incline towards the point where I want to raise. All of the other points near the front would ideally stay at that height and I would like to elevate the top of the object 5/6m above the bottom walls of the object. Thanks again fr te response, some is over my head but I understand most of what you said haha!

Hi there, new to sketch up and after building a few boxes and raising them and what not im embarking on trying to build a 3d model of a rock garden. The outlines are all in but the rock garden is on an incline. I want to raise one corner of the outlined area and lock down others to show the gradient on the rock garden. Im struggling to explain this as im a total newby in this. I have attached a pic to highlight the points i wish to raise and the points i want to keep at their current height. Is this even possible with this program?? Thanks is advance and apologies if this is in the wrong section as i wasn't sure where to go!

Robin.