How can I get cabmaker to user my pullout slide adjust measurements. I only need a 1/2" on each side of the pull out for the drawer slide. No mater where I change the slide adj it always defaults to 1". I am on the trial and have adjusted no settings. Its confusing because its listed in multiple areas. Which on is it.

This is what's in the system and even if I make changes nothing happens).
Rules 2:
Pullout Slide Adj: Default - 2" (When changed nothing happens. Yet when I make it its 1" on each side, not 2".)

Drawers:
Pullout Options:
Pullout Row: 1
Slide Adj: Default 0" (When I change nothing happens.)

If I change both at the same time nothing also happens. Its always 1" on both sides of the pullout.