Thanks for the note Daniel! Your suggestion was not exactly my issue but it was close enough that I was able to figure it out.

Very much appreciate the help!

Dave -

I have a finished model and I want to start putting dimensions to the different parts. To do this I would like to use scenes and layers. Here's how I have it setup:

I have two scenes Main and Bridge with automation deselected. I have two layers Main and Bridge. I made two copies of the model from Layer 0 and assigned one copy to Layer/Main and one to Layer/Bridge. From here I would break down the model copies to the parts I want to focus on.

I then went to Scene/Main and selected only Layer/Main to be visible and updated. I went to Scene/Bridge and selected only layer/Bridge be visible and updated.

My issue is when I go back to Scene/Main it is fine but when I go to Scene/Bridge Layer/Bridge becomes visible but Layer/Main is also still visible. I can reset my visible layers again and update but the changes won't hold.

All check boxes in the Save Scene dialog are selected.

Any thoughts? Is there a better way?

Dave -