@glenn at home said:

My spare laptop did not have Make 17 installed. I down loaded fresh Make 17 install and installed it. Installed current LibFredo and then TopoShaper. Restarted SU and all went well. Something on your end with your user preferences/user setup.

I have already done everything they have indicated, but still without results. Something that has partially worked is the following:

1. create a new administrator account in windows 10
2. Under this account I have run sketchup.
3. I have installed LibFredo6 and Toposhaper in said account
4. Everything works fine on the new account.

But I still don't know why in my main user account I still have errors

@unknownuser said:

User-names can contain all other special characters, including spaces, periods, dashes, and underscores. BUT it's generally NOT a good idea to use spaces in account-names.
On some non-Windows NT systems, such as UNIX, spaces aren't valid in user-names
and the user may have difficulty accessing these systems

Ok. Thanks for the suggestion. I have done the following:

1. I changed the username to a single word
2. I repaired the sketchup installation as administrator
3. I changed the addresses of all folders in the Window> Preferences menu
4. I uninstalled LibFredo6 and Toposhaper
5. I have reinstalled following the recommendations of this forum

Unfortunately, the Toposhaper plugin still doesn't work.

Any other suggestions?

Thanks in advance

---

@unknownuser said:

Did you install SketchUp correctly? That requires right clicking on the downloaded installer and selecting Run as administrator.

Yes, indeed when I installed SketchUp I did it as an administrator

@unknownuser said:

Do you install the correct version or Toposhaper?

Yes, the correct versión of Toposhaper was installed. Now the versión I have is 2.6a

@unknownuser said:

Did you look in the Toolbars list for Toposhaper?

The tool does not show in the toolbar

@unknownuser said:

Your profile says you are using SketchUp 2019 Free/Make. There is no such version. Please correct your profile.

I have changed my profile according the suggestion

The problem persists. In Attached image you can see an error in the tracking log

Can you help me please?

---

I just installed Libfredo6, restarted sketchup, and then installed the toposhaper plugin, then rebooted again and the plugin is nowhere to be found. In the window menu if the LibFredo6 options menu appears. I have SK2019

I have installed Fredo6 lib and then the Toposhaper plugin, however, when I open sketchup it only loads the LibFred6 options in the menu window, but not the toposhaper plugin. Can you help me solve the error? I have read all about similar errors and have put the recommendations into practice but cannot solve the problem. I even changed the version of Seketchup from 2018 to 2019 with no results