Can't push pull a curved surface
-
I have just drawn a flat shape with the intension of push pulling the surface. However when attempting this operation I get the " can't push pull a curved surface> I have seen this before with surfaces I was covinced were flat. However this shape took some time. Does anybody know why this occurs and perhaps a solution to extrude this "flat" shape?
-
Attach your model.
-
Thanks, here it is, but I have chopped it into pieces to push pull bit by bit for diagnosis.
-
Turn on hidden geometry and you can see the issue. You have an soft edge running along the notches.
Remove those edges and it will be a single face.
Whenever you get that error turn on hidden geometry and look for the joint.
-
Nice work as usual, thank you
-
Your geometry is very slightly skewed, I believe probably due to having length snapping enabled.
Go to Model Info/Units and turn it off in all your templates. -
Cheers box. I have done it but do not really understand it I must admit
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement