Up dated Porsche 550 Speedster

HornOxx

Bravo

@aviz770 said:

Awesome stuff! Would love to see some more angles too.

I agree - and maybe a darker colour or any SkUp screenshots to recognize this cool shape better

Bryan K

Looking good!

I would also like to see more angles.

Mike Amos

Thanks folks, a few roadblocks courtesy of Sketchup but as soon as I can.

Mike Amos

The perspex screen has been a headache which has taken a good few hours to sort but it is 'close' enough for now. More of an interior too now.

Oblique view

Bryan K

Looking good!

Mike Amos

Thanks mate, getting issues with flawed geometry now so slow progress.

Bryan K

@mike amos said:

Thanks mate, getting issues with flawed geometry now so slow progress.

Yeah, that's what I run into when I start creating a bunch of curved surfaces.

Mike Amos

Interior, you can see some of the shut lines and panels that are beginning to appear and the clarification of layout for internal components.

Flat Four c 58 10p Ir 0 a R.jpg

Mike Amos

Digging deeper into elements of the body with hopefully opening sections to show engine and suspension details. I also used one of Majid's car paint colours to get a better result from the render. Down to Majid and Twilight render for any kudo's.

Section change.

Mike Amos

I have taken on board some comments about colour which have enhanced the amount of feedback I get from these 'surface development' renders. In this instance, a very slight 'grey' makes a better white than pure white. I hope I am not boring folk but I do get a lot of benefit from feedback, it is very much appreciated.

Surface test next.

Bryan K

Looking great!

shawb

Hats off to you for some great modelling! I tried to model a car a long time ago and soon gave up, it was the curved surfaces that got to me.

@mike amos said:

a very slight 'grey' makes a better white than pure white

I sometimes use a feint fabric texture on walls/ceilings for the same reason. It helps to reduce the 'moire'? effect in renders.

Mike Amos

Thanks folks, very much appreciated and I'm sorry I did not reply earlier. Stuff going on. Back at this today with a few more improvements and sorting shut lines and hinges opening lines/arcs etc. Not got the hydraulic lines etc in yet either but I will get there.

Better?