Create Battlements

d12dozr

For the circular battlements, you can use the Rotate tool and arrays as well.

harry_krueger

Thanks guys.
That was really helpful.

EscapeArtist

mac1

:thumb:

IMHO any of the tools mention rely on a fixed spacing to copy and in almost all cases you will have some boundary value issue wherein the spacing will not result in integer value number of " blocks", so you have have to setup the spacings to solve that problem unlesss that is ok to you?
Can you post( skp) of a small section of one of your problem areas. In one of the post I did some time ago using component stringer and poly line divide worked ok for tank tread but for yours ??

Gaieus

Ah well, in my first answer, I was kind of brief (also posted while I was away and in a hurry).

Indeed a lot depends on the spacing and the roundness of the tower/bastion you want to cover. I usually start with a single component and where I face spacing issues (like they also did when building these structures), I make some unique and adjust the final sizes that way. For parts that are in close-up shots, you may even want to make all pieces unique just to adjust the material (in case it would be "flowing" seamlessly from the walls to the battlement). In more "lucky" cases, you can insert a course of bricks / different stones between them and forget about this latter.

Here is a piece of wall I needed to model as a background for the two houses on the left:

[xxl-img:3ua4d1rw]https://lh3.googleusercontent.com/-LbqhFBAhL4g/TGpXYhYiwjI/AAAAAAAAEgI/6DXttI443Sw/s912/test-002.jpg[/xxl-img:3ua4d1rw]

EscapeArtist

This is why I prefer the divide function for lines and curves. One can use the divide function on the circular battlements as well, the problem being that one would need to either accept a minor deviation in spacing due the differences in length of the wall vs. the length of the circumference. With planning, one could calculate the circumference to match the spacing of the melons and crenels of the wall, or the opposite if desired.

Just as a side note... If you look around on an internet image search, the spacing of crenellation between walls and turrets rarely match, if at all. In fact, a difference could be quite attractive and offer a chance to show off a different style. JMO.

Gaieus

You are right with some few walls and regular sections but when there are hardly any similar wall lengths and tower sizes, always dividing and manipulating those pieces individually can be rather laborious. Here the town and castle walls are quite irregular so I would prefer to use the same component as long as it is not too strikingly repetitive or sticks out too much:

[flash=640,480:13147lbp]http://www.youtube.com/v/x1xgvwvydsc[/flash:13147lbp]

pbacot

Gai,

What town is that? What years are those built--looks like a range of times? Both Dominican and Franciscan Monasteries. Interesting. PB

Gaieus

That's my town in the 14th century (and indeed, some buildings like the Cathedral had already been started centuries before). And yes, both Dominican and Franciscan (and Augustine and Carmelite) orders. The Dominicans also had a nunnery but outside the walls.

Mike Lucey

@harry_krueger said:

Hi guys,

thanks for the input.
While the method you described works great for a flat surface, I am not able to adapt this so it works for a curved surface too.

Take a look at the attachment. Problem is the round towers.
Any ideas?

Harry,

Its a matter of a little advanced planning and then building up the structure. See attached model.

Mike

Battlement.skp