Spiral with half circle edges for skinning-you can do it
-
Remember that I had done in the past with 1001 (Revolution Surface Tool) I believe that it's inside the free version)
-
Another great tip.
Merci, Frenchy, maestro nonpareil.
-
...some old video...no skining,but very exciting
http://www.youtube.com/watch?v=HuKEjp_2nlc&feature=plcp
http://www.youtube.com/watch?v=WojbqmZXSbg&feature=watch_response -
@unknownuser said:
Start from the red square, rotate the diagonal of the half red square = the golden rectangle
each corner gives you a new square by the black arcs circles
You can now draw the red Golden Spiral
Clear as mud, Pilou.
Nice that urgen's first video does the job for us so easily.
(As useful as it may be, I could not find a free version of 1001bit, only trials.)
-
Does this more clear ?
-
You bet it is. I did not mean to trouble you further, though.
-
Cool method and setup page like Chris Ware
@unknownuser said:
You bet it is. I did not mean to trouble you further, though.
Absolutly non problem
-
Crazzy no_problem, amigo. Is possible much larger image?
-
Finally got it done with the original model using Fredo's Curviloft tools and TIGs Extrusion Tools. Five steps to model the half shell.
Never fear. WIP not. Unrendered.
Thanks very much for your help and patience.
-
Yes of course 1024 *512 is my maxi, but not for the previus because I made it on the fly (maybe 30 seconds)
so I have not yet the original!
if you are interested take a look to my little prog
You make any model you want in SU than use my little prog for make some funny variations
-
I am very interested and will try it. You are modest kind, and creative, and most helpful.
But you did not save that image.... Too much flowing.
We cannot capture it all, we cannot hold any of it.
Advertisement