[plugin] EdgeFollowMe - UPDATE Aug 30, 2011
-
No, you can select any number of connected edges or a curve.
-
Follow Me And Keep is really better
-
@sdmitch said:
No, you can select any number of connected edges or a curve.
Thanks make, not really getting that to work. do you:
- select profile
- select start point for extrusion then keep picking around a path or points till finished?
how do you finish; double click?
-
This EdgeFollowMe was meant to be a EdgeFollowMeAndKeep ?
The FAK code is readily amenable to adjustment - swap 'face' for 'curve', and find midpoint of curve.vertices rather than face.vertices etc it should then work much the same... -
Looks like I have been wasting my time if FAK already does this.
Andrew, Just like Sketchup's FollowMe, select the entire path first then run the plugin and select the profile.
-
not a waste of time as FAK does faces and it keeps.
-
FAK works on selected face[s].
BUT you could recast some blocks of its code to process a curve's vertices rather than a face's vertices... -
@sdmitch said:
Looks like I have been wasting my time if FAK already does this.
Andrew, Just like Sketchup's FollowMe, select the entire path first then run the plugin and select the profile.
I was hoping to be able to place a profile in place the pick a path, Sam. At times it's easier to do so rather than zoom out to find the path then execute...
I don't think you have wasted your time at all!!
Thanks Sam.
-
Sorry Andrew but EdgeFollowMe3 is the end of the road.
-
no worries, Sam. Thanks for your input...
Advertisement