Sandbox Contours to Solid
-
OK..so I imported a set of contours and essentially skinned it using the Sandbox tool.
I want to create the skirt and close the object so it is essentially a solid.Once it's a solid, I can perform cut and fill activity on a clone and cmpare the volumes of both.
Any ideas?
TIA
-
An image of your model would help us understand what you need to do, but I'll try...
Select the edges (make sure its a closed loop) around the exterior of the model, use TIG's EE by Vector to extrude those lines down, draw a rectangle under your contours, then intersect the skirt and the rectangle and clean up the extra.
Use Thomthom's Solid Inspector to check for holes.
-
awesome. workes a treat! thx.
-
Great! You're welcome
-
just chucking in that this helped me with something I was stuck with too so Cheers
Advertisement