Curviloft ''narrowing''

[srx]

Yes. Use Follow me tool.

[pilou]

Don't understand the question!
You want the same width along the form ? Or height ?

In any case it's always a good thing to save as V6 for a more large audience!
Here I had the 2016 open so obliged to open the 2017 !

[pbacot]

You might try Extrusion tools which will define a path along rails. FollowMeAndKeep too.

[Dave R]

Is this what you're trying to achieve?

[pipingguy]

yes, dave r. - but with the simplicity and speed of the curviloft tool. is that what you used?

[pipingguy]

pilou - i saved as ver 6 just moments ago.

[Dave R]

@pipingguy said:

yes, dave r. - but with the simplicity and speed of the curviloft tool. is that what you used?

No. I drew a path and used Follow Me. If you use Curviloft, you'll need to make the right settings to maintain the cross section dimensions. And you'll need a cleaner curve between the ends.

[pipingguy]

Just to complete this subject, hopefully the creator of the extension reads this post so he may attempt to improve the issue. If that's even possible.

[Dave R]

What's to improve? It does what you asked for already with the right settings.

[pipingguy]

My goal is to connect two offset rectangles with the speed and simplicity of using Curviloft - but without a reduction in aspect ratio. Want to avoid the extra step of manually drawing a path between said rectangles.