How? Roundover All Edges Of Cube
-
Newer verions allow to use a double click in the near of a corner to repeat the last rounding...
-
I've followed the directions, but I'm still getting screwy results.
So here's some screen caps. The first is the setup. I've got a 14x14 square with 1/8" rounded corners as the base, and a 3/4" x 7" profile with the right end dead center of the square about 2" off the base.
When I go to extrude, I get this message that the extrusion doesn't begin and end on the profile, and then all the corners are open...
-
OH! Guidelines, of course! That alone will speed up the process.
But I can't seem to get the darn thing to do a tangent corner round to save my life. Sketchup is balky in my hands... -
-
Hey... Be nice. I'm a slow learner...
-
Did you see my PM to you?
-
Well @#!%$!
I made the profile and square a component. Then I scaled it up 100. Then I extruded. It looked great. Then I saved... and then it looked like this:
-
I didn't know I had a PM, because I'm not sure where the flag shows up. But I answered it.
-
So I tried the corner rounding trick in Version 2014, and I can get as far as the tangent arc, but don't see how to get it to crop...
-
Don't fight it anymore. I'll show you soon.
-
@turninman said:
So I tried the corner rounding trick in Version 2014, and I can get as far as the tangent arc, but don't see how to get it to crop...
I don't think 2014 is a newer version
-
Ha Ha!
It's a lot newer than V7 and V8! -
Hey Dave,
I'm re-creating what we did the other day, and got so far as selecting the edges of the new panel using hidden geometry and trying to scale it up...
We didn't use scale for that did we? Did we just use the "move" tool to make the panel bigger? -
Yes. We just selected the end of the panel and used the Move tool. You might find it easier to see your selection if you use X-ray face style in addition to showing the soften edges with View>Hidden Geometry. And remember, it's a left to right selection around the end.
-
Got it. Thanks again for all your help!
-
Happy to help.
-
@cotty said:
Newer verions allow to use a double click in the near of a corner to repeat the last rounding...
D'oh!
Advertisement