MIDDLE-LINE - HOW TO CREATE?
-
hi everybody,
i just came across the problem to draw a middleline of a road automatically.
has anybody an idea, if there is a ruby, which can calculate the middle point in the geometry step by step and draw a line between these centerpoint?
the red line shall be the result.
thanx a lot
stan
-
What about Fredo's ToolsOnSurface - Offcet on Surface?
-
@dedmin said:
What about Fredo's ToolsOnSurface - Offcet on Surface?
hi, thanx, yes, i already tried,
but at the moment a get doubled lines in the middle , when the offset = 1/2 of the width.so creating a curve from the middle - line by WELD does not work yet.
still trying.
regards stan
-
Alternatively, you could use Curviloft (loft by spline), with
- the 2 side contours
- asking for 2 segments (2s)
- in geometry parameters, as only for grid
Fredo
-
Use line, not surface
-
@yorik1984 said:
Use line, not surface
@yorik1984 said:
Use line, not surface
to fredo:
hi, i get to this point, but quitting / ok / whatever let the lines disappear again. how can i extract the middle line?
thanx stan
-
@artmusicstudio said:
@yorik1984 said:
Use line, not surface
@yorik1984 said:
Use line, not surface
to fredo:
hi, i get to this point, but quitting / ok / whatever let the lines disappear again. how can i extract the middle line?
thanx stanto yorik1984:
thanx, yews, with one line it works. great.
thanx stan
Advertisement