WIRED MAGAZINE 3D COVER PRINT
-
Thanks, I also did a feature opener in the same issue. In print it was a double page spread and on the ipad version shown here its just a single page.
Not shown here i actually completed the entire facility even though only a small percentage was used. I dont have any shots but it looked similar to this: http://solarpowerpanels.ws/wp-content/uploads/2010/02/solar-thermal_ORxjh_69.jpgIts a solar farm, made in SU and then they used the wireframe as part of the design.
-
Great stuff Liam...as always.
-
Congratulations on being published. I have seen polystyrene being cut by a hot wire for something simple like this.
-
Great Lliam. Congratulations
Wired is such a good mag. -
Very Cool!!! Congrats. Very encouraging to see.
-
@earthmover said:
Very Cool!!! Congrats. Very encouraging to see.
Thanks - I think as the printing tech gets cheaper we will see a lot more exciting things!
-
Great work....and I really hope that Trimble reads posts like this and makes 3D printing fully integrated with future versions of SU.
-
@hieru said:
Great work....and I really hope that Trimble reads posts like this and makes 3D printing fully integrated with future versions of SU.
In a way it already is - you can export directly in a recognised file format ready for print.
Perhaps if SU included some pre flight checks to make sure the model was ok and any delicate potential trouble sections got flagged up? -
Congrats, well done
-
Congrats! I had my first professional 3D print used earlier this year for an international phone game company.
Again, congratulations!
Advertisement