Model a "infinite"
-
How can I model this drawing in Sketch-up?
Thanks
-
I'd start by constructing a solid Moebius strip without any compartments, then use Tools on Surface followed by Joint Push pull to create the hollows.
The attached skp file shows how ro make the strip. As I point out in the file, it needed a teensy bit more of an offset to allow the two sections to pass each other cleanly...but you get the idea.
-
Alan, I'm very disappointed that your model wasn't perfect
JK, nice little tutorial
-
@luisto said:
How can I model this drawing in Sketch-up?
Thanksthanks for helping me . And how can I build the corbels? Thank goodness
-
As I said in my original post, use Tools On Surface to draw out the pattern of recesses on the surface...then use the Joint Push Pull script to intrude them.
-
Here front is not not also the bottom
That is not a Moebius ribbon!
For that it must have only "one face" (not included thichness)
-
@alan fraser said:
I'd start by constructing a solid Moebius strip
Technically, that object is not a Mobius strip.
-
I know...on the other hand it's not an infinity sign either...that's 2D. I had to call it something without being too pedantically long-winded.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement