Problems push/pulling a hole
-
I have a flat rectangular block of 2mm depth by 20mm square.
I have drawn a circle on its surface and i want to make a hole through it by push/pullig the circle.
As i P/P the face of the circle, it will extrude above he surface but its behavior going through the block is erratic. it will seem to do nothing and then appear on the other side of the block. sometimes i get the error 'cant PP hrough a curved surface' (its not curved)and i don't get the message to say its in line with the opposite face - even if i enter the exact width numerically.any ideas?
-
It sounds to me as if you either have the circle drawn outside a group or component. If so, the Push/Pull tool will extrude a cylinder but it won't create a hole because the plate, being in a group/component is protected from being modified. Delete the circle, open the plate g/c for editing and then draw the circle and push it through.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement