Set depth of wood

ivantwohig · 21 Mar 2011, 09:39

I have a low polygon 3D model the I want to break apart into flat triangles and cut out of wood.

Is there a way/plugin to set the depth of the wood and that automatically calculates the angle at the edges where two polys meet?

E.g. if i wanted to make a cube out of 2CM thick wood it would calculate the edge angle at 45 Degrees.

Any suggestions?

Thanks

TIG · 21 Mar 2011, 10:03

If you get 'JointPushPull' and have a go at tweaking its settings ['borders' etc] you can get this effect It doesn't separate the angled pieces... but at least you get all of the required faces you need to group them together later...

ivantwohig · 22 Mar 2011, 00:22

That's great. Thanks Tig.