Extrude Edges by Face

charly2008 · 22 Jul 2010, 12:07

Hi,

this church, I started about two years ago. The vault in the back I finished with EEbyFace. If I had had EEbyFace before many things would have been simpler. In the picture below I have the main vault again completely built with EEbyFace.

And here is another tip. I always have difficulties to predict the orientation of a profile. I've helped me so, as I donned the desired profile into four quadrants. In the model I selected the appropriate Arcs and tried each quadrant showed up the profile in the desired direction.

Charly

Untitled.skp

pilou · 22 Jul 2010, 12:37

Cool use of crazzy plug

guillermorage · 28 Jul 2010, 05:35

where can i download it?? how does it works??

TIG · 28 Jul 2010, 08:53

@guillermorage said:

where can i download it?? how does it works??

http://forums.sketchucation.com/viewtopic.php?p=217663#p217663 takes you to the Extrusion Tools download page - it's a part of these tools. On that page are links to each individual tool's thread, each of these has a set of instructions on its first page - many also have further examples and advice in later posts in that thread...