Help - overlapping planes created by dividing a face
-
Hello,
If anybody can resolve this one easily I would be most grateful.
Basically, when I draw a line across a face that is approximately rectangular, one that divides the face in two, sometimes sketchup creates two overlapping planes, or three or four planes. Why is this? Anybody got any quick good ideas?
As far as i can tell, all points on the face perimeter are in the same horizontal plane.
thanks
-
Especially with the new, edge cutting feature of SU 7, this is much less frequent than with older versions. There can be many reasons, best would be if you could upload an example.
-
I've been getting this a lot
the method I've been taking is to delete the face I'm dividing then draw the dividing lines in, then selecting each subface to remove any extra faces using the delete tool.at times I've had 4-5 stacked faces that I've had to remove before I started doing the above.
oh and an easy way to find stacked faces other than the Xray face mode (stacked faces show up darker) is with the paint tool.. if a face won't paint, it's stacked...
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better đź’—
Register Login
Advertisement