Thanks Gilles!

I did the model from two extruded shapes and intersect them, after I generate the shape of the phase shift, like the components in the file I upload before, then I explode all components. (basicly)

I just do that!, and still happens.
I go upload a .skp file and a picture of the element what I need model.
Is a Sheet of steel, what simulate a tile roof.

a thousand of thanks!!

PD: the escale in the skp file is 1000/1

SU version: Sketchup Pro 2014

When I do, the errors in geometry are the same, like if I had not scaled...

Thanks Dave
But, when I scaling up the model, it is not necessary also scale the offset factor too?
in this case the problem is not still happening?

thanks

Hi there!

I have a serveral issue to round a complex edge

when I check whith the solid Inspector plugin, the result is fine

I set the round Corner Plugin and run

and the result is full of surfaces borders and internal faces edges.

can you tellme why?

Thanks a lot!