@bob james said:

@frommer1 said:

@gaieus said:

Could you attach the file,please? (Maybe a "before" and an "after" version of the same geometry in it)

Here is is. i tried rounding the corners on the left hole and it is gone. the hole on the right is untouched. Please help! i tried erasing the center and the only way it shows up is if i delete some lines on the roundover

I clicked on the area where the left hole should be. It was "filled in" as evidenced by the blue dots. I then deleted the "blue dot" area and was left with a rounded edge hole as expected.

Thanks a lot. i did what you said and got the required result. I am new to Sketchup and am still learning!

@gaieus said:

Could you attach the file,please? (Maybe a "before" and an "after" version of the same geometry in it)

Here is is. i tried rounding the corners on the left hole and it is gone. the hole on the right is untouched. Please help! i tried erasing the center and the only way it shows up is if i delete some lines on the roundover

test hole.skp

@gaieus said:

@frommer1 said:

i am trying to round over the edges of a circle that is through a rectangle, as if you cut a hole in a piece of wood and then rounded the edges over. How do i do it. evertime i try it just closes the circle

Since it creates new geometry, I can imagine that those faces also are created automatically. What happens if you delete the circle(s)? Is the rounded edge there underneath?

it appears to go away completely, as if it were never there

@bob james said:

@frommer1 said:

i need help loading the plugin i downloaded everything as stated, but when i open sketchup, nothing is there how do i load the plugin?

See the directions on page 1 of this post: welcome to SketchUcation

I did and it still doesnt work on my laptop. I even erased the files and tried again. Any ideas. i was able to sucessfully load the plugin on a different computer however.

i am trying to round over the edges of a circle that is through a rectangle, as if you cut a hole in a piece of wood and then rounded the edges over. How do i do it. evertime i try it just closes the circle

i need help loading the plugin i downloaded everything as stated, but when i open sketchup, nothing is there how do i load the plugin?