Posts made by Eco15

you are absolutly right. i didnt catch that in the youtube movie - thanks a lot!

Hello,

i dont know if it came up along the 15 pages of feedback, but i downloaded the plugin, and seems to be installed OK. when adding a section from sketchup and right-clicking it the add section cut face appears and doing its job BUT the CUT MODEL AT SECTION command doesnt apear afterwords. i try using Versions 2014 / 2016 / 2013.

i read on the download page that it's possible to have problems with V.2014 and that i should contact Via PM (which i can not do yet - hence, writing here). i have a presentation due to the end of the week and will appreciate all help.

NOTE: i tried using the plug-in in a simple model just to make sure that the amount of Info is not the problem.

Thanks.