![This is the point that shows that the "Contours" do not match the landscape. How do I enlarge the "Contours" to suit the plan? I tried to upload the file but it says it was too large. Then I tried to upload a .tiff; it said that .tiff was not allowed so I am sending a .jpeg](/uploads/imported_attachments/dFae_LandscapeFredo6.jpg "This is the point that shows that the "Contours" do not match the landscape. How do I enlarge the "Contours" to suit the plan? I tried to upload the file but it says it was too large. Then I tried to upload a .tiff; it said that .tiff was not allowed so I am sending a .jpeg")
Latest posts made by try2
-
RE: Fredo6 Toposhaper
-
Fredo6 Toposhaper
I am using Fredo and have successfully created a terrain from .dwg topographical points.... then bugsplat I have a file saved to this point but anxious to avoid repetition of crash, I took old 'pre-terrain' file and have it back at the point of all the points in a group but when I go to 'Create Terrain' the area selected is far smaller than my whole terrain. I know there are 3 red boundary Contours to choose from: Convex Hull - Concave Hull - Best fit Rectangle but how do I alter or create a boundary the right size? The time I got to make Topo work before, I never had this problem. It formed the terrain automatically to the right boundary. Now no matter which CONTOURS box I select it simply produces a small od area centre plan and this is the only bit that goes green..... Anybody know?? How to set a boundary to suit?? Thanks