Drawing irregular floor pattern problem

[syburn]

sigh.......its me again.

If i am using line tool to trace out a curved irregular floor pattern (so that i can add a material to it), how to constrain all these lines to a base axis so that it will make a face. Using shift does not work as it only lets me draw squared shapes at red gree axis.

P: syburn

[Gaieus]

If you go "Top view" (Standard views), SU will tend to draw on the red/green (horizontal) plane.
However you can also draw a huge rectangle before starting and use that as a "drawing board" - SU will tend to draw "on face".

[syburn]

much appreciated!!!

P: syburn