Medeek Wall Plugin
-
Version 4.4.5 - 04.05.2026
- Fixed a bug with the profile cutting of balusters.
- Enabled a new boolean subtraction algorithm for profile cutting of balusters.
-
Version 4.4.5b - 04.08.2026
- Added a tooltip for the Corner Treatment option into the Global Settings, Draw and Edit Wall Menus.
I didn't realize that the term "California Corner" was not well known in the industry. To that end I've added a tooltip for "Corner Treatment" which shows a typical (2x6) California Corner and a U-Corner. Hopefully this further clarifies this parameter for some users who are not familiar with this term. The other corner treatments seem fairly self explanatory.
-
I've been meaning to add in a "Style 6" door hardware option for quite some time. Basically something for your entrance door, and I haven't had a good option for this until now. This low poly entrance hardware and deadbolt (handleset) is loosely modeled after the Camelot series by Schlage. I will include this in the next roll out:
-
Version 4.4.6 - 04.11.2026
- Added a "Style 6" (Schlage - Camelot) to the built-in door hardware options.
- Configured the "Ctrl" hot key within the draw door tool with additional justification options (x-dir).
Tutorial 84 - Positioning Doors (7:19 min.)
-
Version 4.4.6b - 04.12.2026
- Added custom door positioning offsets into the Door tab of the Global Settings.
-
Version 4.4.7 - 04.16.2026
- Fixed a bug with custom door positioning for metric templates.
- Enabled "profile cutting" of posts for vertical handrails.
- Fixed a bug with the bottom trimming algorithm for balusters
.
-
Version 4.4.8 - 04.18.2026
- Enabled custom components as posts for vertical handrails
-
Tutorial 85 - Profile Cut Newel Posts (9:04 min.)
-
Version 4.4.8b - 04.18.2026
- Enabled custom components as balusters for vertical and OTP handrails.
Th sub-folder structure is the same as for newel posts, so Tutorial #85 is applicable to balusters as well.
-
Version 4.4.8c - 04.19.2026
- Fixed a minor typo in the stair module.
- Added a ornamental iron baluster into the baluster component library.
The limitations of profile cutting balusters can be overcome by using a predefined component instead, which allows for much more intricate baluster geometries.
However as I have been researching various baluster layouts I've noticed that with iron balusters usually more than one baluster style is utilized. The typical scenario is two or three different baluster geometries are alternated along the run of stairs. I will need to give this some more thought.
Stairs can be a "rabbit hole".
-
Version 4.4.9 - 04.19.2026
- Enabled a secondary custom profile/component parameter for balusters.
- Added additional ornamental iron balusters into the baluster component library.
I think I've beat this horse to death. Hopefully with this added option we can configure most of the common baluster layouts, however there will always be a few that will be beyond the scope of the plugin (ie. three or more baluster types in various repeating patterns).
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better đź’—
Register Login
Advertisement